This is done only once, and sometimes more than one port needs to be tested. Then the download panel will appear, from where we are going to configure some parameters: En Settings, We will establish that the port to use will be the COM4, The baud rate we chose 1200 Parity none, Data bits 8 And stop bits 1. This can be opened in the future, in case we close the program and need to return to the same project. The following is just select the OK option, with the format SDR33, then a message will appear indicating that it is being transferred, and the amount of points in process.īe careful, this is done until the connection from Prolink has already been configured, which is explained below.įor this, we do File New Project, And assign the name of the file, which will be stored in the format SPP. Note that when selected, instead of showing the number of points captured, it changes to the text Out, Which means it is ready to be transferred. Prepare the station for transfer Having the transfer cable connected ( USB to serial converter ), It is indicated that what we hope is to transfer data, and which works: MEM JOB Then we do Enter. It occurs to me that in that Xder Of desperation inserted it and pulled out the perverse, and that caused the chip to burn. Software Sokkia Sdr Software To Reinstall.
0 Comments
Leave a Reply. |